Brooksville to Naples and everywhere in between on Florida's Gulf Coast
Hardwood Floor Restoration and Refinishing
Scratched, dull or water-marked wood usually needs a refinish — not a tear-out.
What you get
- Dustless sanding and full refinish — oil or waterborne polyurethane
- Screen and recoat for floors that are dull but not worn through
- Board replacement, gap filling and pet-stain repair
- Engineered wood buff-and-coat where sanding depth is limited
- Stair treads, thresholds and transitions matched to the floor
- Satin, matte or semi-gloss sheen — you pick before we coat
Why this matters in Florida+
Florida is hard on wood floors: sand grinds through the finish at every doorway, humidity swells the boards and sliding-door sun bleaches whole rooms. In most homes the wood underneath is still thick enough to sand, so we bring the floor back for a fraction of replacement cost. Refinishing runs $3.00–$6.50 per square foot, and a screen-and-recoat on a floor with an intact finish costs far less.
Step 1 — coverage
Our process
Four steps, one visit
- 01
Depth and finish check
We confirm the wear layer is thick enough to sand and identify the existing finish before quoting.
- 02
Dustless sanding
Vacuum-shrouded belt and edge sanders take the floor to bare wood with almost no airborne dust.
- 03
Repair and stain
Damaged boards swapped, gaps filled, then stain applied and approved on-site.
- 04
Coat and cure
Two to three coats of polyurethane. Light foot traffic the next day, furniture after cure.
Ready for hardwood?
Lock in a flat price before we drive out. It takes under a minute and there's no obligation.
FAQ
Hardwood questions
Can my hardwood be refinished, or does it need replacing?+
If the boards are solid and at least 3/32 inch of wear layer remains above the tongue, they can be sanded and refinished. We measure before quoting. Engineered floors with a thin veneer get a buff-and-coat instead.
How much does hardwood refinishing cost in Florida?+
Sand-and-refinish runs $3.00–$6.50 per square foot depending on the finish, stain and repair work. A screen-and-recoat on a sound finish is significantly less. You get a flat price up front.
How long before I can walk on the floor?+
Light socked-foot traffic the day after the last coat, area rugs and heavy furniture after about a week so the finish fully cures.
Do you handle water damage and pet stains?+
Yes. Dark pet stains that have penetrated the wood are cut out and boards replaced. Cupped boards from a leak often flatten once dry and can then be sanded level.
Hardwood service across the Florida Gulf Coast
We cover brooksville to naples and everywhere in between on florida's gulf coast — Tampa Bay, Sarasota-Bradenton, Charlotte County and Southwest Florida.
Other services
Grout & Tile Cleaning and Sealing
Dingy grout restored to a uniform, sealed finish — no replacement needed.
Carpet & Upholstery Cleaning
Deep extraction cleaning that lifts pet odor, traffic lanes and Florida humidity smells.
Pressure Washing & Paver Sealing
We restore the surface, not just rinse it — then seal it so it stays clean through the rainy season.
Terrazzo Restoration & Repair
Bring original mid-century terrazzo back to a mirror finish — for a fraction of replacement.
Marble & Natural Stone Polishing
Etch marks and dull spots are surface damage — we grind them out and re-polish.
Epoxy & Concrete Floor Coating
A coating is only as good as the prep — we grind, not acid-wash.
Free estimates, honest pricing, no upsell games
Tell us what floor you're dealing with and we'll give you a straight answer and a flat price.